I am working with the TIDEP-01032 example from the AM243x Motor Control SDK 09.02.00 and don't understand how the EtherCAT Firmware is loaded onto the PRU-ICSSG. In the EtherCAT Slave Simple Demo, ...

Can the IN+ and IN- of the INA180-Q1 current sensing operational amplifier meet the 5B pulse requirements? (Note: The front-end circuit will have a TVS tube, clamp voltage: 38.9V) ...

I encountered a problem when debugging the HRPWM. The EPWMCLK is 100MHz，I think the MEP_ScaleFactor should be 65 or 66 cause the MEP step size is 150ps. But when I use the SFO function, the ...

TPS61165DRVRG4 is constant current LED driver. The LCD module backlight has a spec for both voltage and current. for example, our backlight has a current spec 180mA and voltage spec typ 9.6V, max10.2V ...

I am configuring a new laptop with TI development tools, using the same products as on an older computer. The older computer has been running CCS version 12.4 and C2000ware version 5.02.00.00 for over ...

I would like to know if there is any easy way to add a protection for short circuit between led+ and led-? It happens quite too often that we destroy either the diode or Rset during the assembly ...

I am using the EMIF interface to access both an external SRAM and an FPGA. Do you recommend adding series resistors (10-22 ohms each) to the EMIF signal lines, since the interface will be running at ...

I am trying to use TPS61165 IC. I am using this IC for LCD Back light control, Which has 27 LED (3S ,9P). Required LCD backlight forward voltage: 9.6V (Typ) Required LCD backlight forward Current: ...

We have found LM5064 for the solution. As per the datasheet page#21 to maintain accuracy, the sense resistor voltage should not be less than 3 mV. But our calculated Vsense voltage comes near 1.5mV.

firewall can config channel (register) and region (memory usage) and must be 0x40000 aligned. in firewall if I config msram 0x70000000 to be locked, is it esquivent that In mpu config, I config msram ...

I'm attempting to create a dual integrator to measure distance from an accelerometer. We have the ACF2101 but we need a larger capacitor for the integration time which is 2 seconds. Schematic is here.

Is it possible to use the signal from the IPROPI pin to perform ripple counting of the brushed dc motor being driven by the DRV8873-Q1 or is the signal not meant for that kind of high resolution ...